Neuspeed 62.10.93 Power Pulley Kit Volkswagen 2013.5-Up

 NEUSPEED since 1975, nobody comes close to our record of industry first aftermarket products for VW/Audi vehicles; we set the industry standards for design, innovation, quality of materials, fit, finish and attention to detail.

NEUSPEED  Power Pulley Kits have been available for over 20 years with no reported engine failure or reduce engine life and all pulley's are made in USA. With so many of our current products being copied and being the first to offer the TSI Pulley Kit we ask that you support the innovator NEUSPEED not the imitators.

Your car's alternator and A/C are powered by a belt connected back to the crankshaft pulley. Spinning these pulleys draw precious horsepower from your engine. NEUSPEED's powertrain engineer, using sophisticated CAD software, performed a mass properties analysis of the crank pulley. The result is reduced parasitic drag on the engine, increased horsepower, better response and quicker reving. This kit includes a new under-drive crankshaft pulley, crankshaft bolt and ribbed belt.

The NEUSPEED crankshaft pulley is made from 7075 aluminum and hard anodized for durability and wear, plus a NEUSPEED exclusive: stainless steel ring that has been ground finished and heat treated to prevent pulley wear against oil seal.

Notes:

2013.5-UP Jetta GLI & Beetle 2.0 TSI 210HP (CPLA, CPPA) and 2014-UP Passat & Jetta 1.8 TSI (CPKA, CPRA) and 2018 Passat/Beetle 2.0 TSI 174HP (DDSA) engines.

NOTE: Factory tool required and professional installation recommended.

Pulley Weight:

• Stock  4 Lbs. (64 ozs.)
• NEUSPEED  13 ozs.

20% Under-drive reduction

5-7 horsepower gain.