In-Tank Fuel Pump Module - PA-Series

For over 20 years Tanks Inc has been retrofitting non EFI gas tanks with internal fuel pumps using their PA Series EFI Gas Tank Conversion Module.  This In-Tank Fuel Pump module can be used to retrofit an internal fuel pump into your original gas tank.   

This kit gives you everything that you need to install an internal fuel pump into nearly any tank. The PA Series fuel pump kit features a reservoir tray that eliminates fuel pump starvation that is common on non-baffled tanks.  A properly installed internal fuel pump will essentially eliminate any issues that are common on external fuel pumps such as vapor lock and cavitation.    

The pumps listed are capable of running up to 100 PSI and they will deliver a varying amount of fuel (gallons per hour) depending on the pressure. We have recorded the GPH at 30, 40, and 60 PSI as a guide to finding the correct pump for your particular installation. In addition, you can use the following list as a general rule of thumb for some of the more common engine swaps. See below for Installation Instructions.

Pump Flow Rates:

TBI 109 Liter Per Hour Pump

• 29 GPH @ 12 PSI

 PA-2  Deluxe 190 Liter Per Hour Pump                   

• 54 GPH @ 40 PSI                                         
• 50 GPH @ 50 PSI
• 48 GPH @ 60 PSI

PA-4  High Flow 250 Liter Per Hour Pump

• 68 GPH @ 40 PSI
• 65 GPH @ 50 PSI
• 62 GPH @ 60 PSI

PA-6  High Performance 400Liter Per Hour Pump (500 - 1000 Horsepower)

• 106 GPH @ 40 PSI
• 99   GPH @ 50 PSI
• 91   GPH @ 60 PSI

NOTE: All Flow Rates Are At 13.5 Volts